12.
Click Focus Autolearn.
Tip: You may have to click Image Settings again before you can click Focus Autolearn.
Note: The Reading Distance value is not significant until the Focus Autolearn procedure ends
successfully.
The Calibrate dialog box opens allowing you to start the procedure.
13.
Click Start.
At the end of the calibration you can see the new Reading Distance and Image Density (PPI) values as well as the
FOV dimensions.
Figure 55. Reading Distance, Image Density, and FOV Dimensions
14. Click Apply.
Note: To enlarge the visual image of the code view, click the zoom image icon, repositioning it
on the code.
Note: At this point it is good practice to save the
configuration from temporary memory to
permanent memory, giving it a specific name.
15. Place an
application-specific code in front of the reader and only click Image Auto-Setup to register any changes in
lighting or code surface contrast.
ABR 7000 Series Barcode Reader
www.bannerengineering.com - Tel: + 1 888 373 6767 45
To Next Page
Loading...