6.7 Output Setup
1. Configure
your application-specific Digital Output(s) and Green/Red Spots (if used) from the Configuration
Parameters tree area: Output 1, Output 2, etc.
Figure 67. Output Setup
2. Save the configuration from temporary memory to permanent memory, overwriting the previously saved
configuration.
6.8 Fine-Tuning Examples
The following examples show some of the typical conditions occurring during the installation and how they can be tuned
manually.
6.8.1 Under-Exposure
To correct an under-exposure result it is recommended to change the following parameters in their order of appearance:
1.
Increase the Exposure Time.
2. Increase the Gain.
Note: In general, a longer exposure time corresponds to a lighter image but is susceptible to blurring due
to code movement. Exposure time is also limited by the Internal Lighting mode parameter. Longer
exposure times can be set if the power strobe level is lowered.
High gain settings may produce a grainy image that may affect the decoding process.
ABR 7000 Series Barcode Reader
54 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...