2. Configure your application-specific Data Formatting Message(s) from the Configuration
Parameters tree area:
Message 1, Message 2, etc.
Figure 66. Data Formatting
3. Add fields to the output message by clicking on the icons above the Message Field area.
The fields are appended to the message.
4. Drag the
fields to position them between other fields in the message so that the output message is ordered
according to your application requirements.
Each field has its own relative configuration parameters in the parameters panel.
ABR 7000 Series Barcode Reader
www.bannerengineering.com - Tel: + 1 888 373 6767 53
To Next Page
Loading...