What to do if motion monitoring has detected a fault in Banner Scanner?
If the Banner Scanner's motion monitoring has detected a fault, check the vehicle's speed and travel direction. Also, check the control system's Field Pair switchover.
How to recover from a lockout condition on Banner AG4 Scanner?
To recover from a Lockout condition of your Banner Scanner, ensure all errors are corrected and then perform a reset routine. Alternatively, you can cycle the power.
What to do if there are errors on the Field Pair control inputs of Banner Scanner?
If the Banner Scanner experiences errors on the Field Pair control inputs, check the Field Pair switchover, switchover sequences, and switchover times. Ensure that at least one Field Pair is always active.
To Next Page
General
