VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
AUTOLK –
Automatic
Keypad Lock
When ON, the keypad will be locked if not
used in 8 seconds. Pressing the [#╓O] key
for 2 seconds will unlock the keypad.
SFT-D - Frequency
Shift Direction
OFF [0]: TX = RX (simplex)
+ [1]: TX will be shifted higher in
frequency than RX
- [2]: TX will be shifted lower in
frequency than RX
Enables access of repeaters in
VFO/Frequency Mode
OFFSET -
Frequency shift
amount
00.000 - 69.990 in 10 kHz steps
Specifies the difference between the TX
and RX frequencies
MEM-CH - Store a
Memory Channel
This menu is used to either create new or
modify existing channels (0 through 127)
so that they can be accessed from
MR/Channel Mode.
DEL-CH - Delete a
memory channel
This menu is used to delete the
programmed information from the
specified channel (0 through 127) so that it
can either be programmed again or be left
empty.