Baofeng UV-3R+ - Page 3

may result in RF exposure levels exceeding the FCC requirements
for wireless RF exposure.
To ensure that your expose to RF electromagnetic energy is
within the FCC allowable limits for occupational use ,always
caution adhere to the following guidelines:
| DO NOT operate the radio without a proper antenna attached, as this
may damaged the radio and may also cause you to exceed FCC RF
exposure limits. A proper antenna is the antenna supplied with this
radio by the manufacturer or antenna specifically authorized by the
manufacturer for use with this radio.
oO DO NOT transmits for more than 50% of total radio use time ("50%duty
cycle"). Transmitting more than 50%of the time can cause FCC RF
exposure compliance requirements to be exceed .The radio is
transmitting when the "TX indicator" lights red .You can cause the
radio to transmit by pressing the "PTT"switch .
ALWAYS keep the antenna at least 60cm away from the body when
transmitting.
The information listed above provides the user with the information needed
to make him or her aware of RF exposure, and what to do to assure that
this radio operates with the FCC RF exposure limits of this radio .
Electromagnetic Interference/Compatibility
During transmissions, your UV-3Rt radio generates RF energy that can
possibly cause interference with other devices or systems .To avoid such
interference, turn off the radio in areas where signs are posted to do so.
DO NOT operate the transmitter in areas that are sensitive to
electromagnetic radiation such as hospitals, aircraft, and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed
as consequence of their employment provided those persons are fully
aware of the potential for exposure and can exercise control over their
exposure.
The maximum duty cycle in VOX mode is 50%.
a BAOFENG
PRECAUTIONS
Refer service to qualified technicians only.
Do not disassemble or modify the transceiver for any reason.
Do not expose the transceiver under direct sunlight long or to
extremely hot condition.
Do not place the transceiver on the unstable surface.
Keep the transceiver out of dust, moisture, water.
Do not operate the transceiver or charge the battery pack under
explosive conditions.
SAFETY
It is important that the operator is aware of and understands
hazards common to the operation of any transceiver.
A\warninc
Please turn off the transceiver off at the following locations:
> In explosive atmospheres (inflammable gas, dust particles, metallic
powders, grain powders, etc.).
While taking on fuel or while parking at gasoline service stations.
> Near explosives or blasting sites.
> In medical institutes or aircrafts.
changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
y N