Baofeng UV-3R+ - Installing;Removing the Battery Pack; Battery Charging

BAOFENG
NOTE:
Do not recharge the battery pack if it is fully charged. Doing so may cause
the life of the battery pack to shorten or the battery pack may be damaged.
INSTALLING/REMOVING THE BATTERY PACK
The usage time of Battery Pack is about 8 hours, which is based upon
5% transmit 5% receive 90% standby (standard duty cycle). See following
images:
Figure 2
CAUTION:
1.Do not short-circuit the terminals of the battery or throw the battery
into the fire.
2.Do not disassemble the battery pack yourself.
BATTERY CHARGING
Please charge the new battery pack before using it.
The new or stored (more than two months) battery pack, which can
not reach its full capacity for the first charging. After 2 or 3 times
charging and discharging, it can reach full charge.
04
y N
BAOFENG
JUST SEE THE FOLLOWING INSTRUCTIONS
1.Plug the adapter into an electric socket.
2.Insert the transceiver or battery into the drop-in charging tray.
3.Ensure that the battery's contacts connect with the drop-in charging
tray properly, while the charging is taking place, the light will glow red.
4.After 3 hours charging, the LED indicator will light green which
means the full charge. Now remove the battery or the transceiver from
the drop-in charging tray.
Important Note:
1) Perform the battery charging where the ambient temperature range is
41°F~95°F (+5°C~+35T).Charge out of this range could cause damage
to the battery pack.
2) If the charge is not completed in several hours, the battery may be
deteriorated. Do not attempt to forcibly charge the battery, please
contact the dealer.
3) If you do not use the transceiver for a long time, remove the battery
pack from the transceiver, as battery leakage could cause damage to
the transceiver and the battery pack.
4) While in storage, the charge will drain slightly over time and the battery
should be recharged 50% each six months.
05
7 N