baracuda Captura Plus - Storing the Cleaner

3. Grasp the handle and lift up to remove the
lter canister (Figure 17).
Figure 17. Remove the Filter Canister
4. Press two latches (1) and remove the lter
canister lid (2). See Figure 18.
Figure 18. Remove Filter Canister Lid
1
2
1
5. Using a hose with clean water, rinse the lter
canister and lid to remove all debris (Figure
19).
Figure 19. Rinse the Filter Canister
6. Let the lid and lter canister dry.
7. Replace lid on the canister and then replace
canister back into the cleaner body.
8. Plug the oating cable back into the Control
box and store the cleaner out of direct sunlight
for next use.
3.7 Storing the Cleaner
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as acetone
or its equivalent. Rinse the cleaner generously using
clean water. Do not let your cleaner dry in direct
sunlight near the pool. The cleaner must be stored on
its caddy so that it dries quickly.
1. Starting at the cleaner head. Remove all coils
and tangles from the cable (see Figure 20).
Figure 20. Untangle the Floating cable
Section 3. Operation
H670900_REVA 11