baracuda Captura Plus - Troubleshooting; Using the Information LED

Section 5. Troubleshooting
5.1 Using the Information LED
The information LED on the Control box ashes in a specic sequence to indicate one of three possible
cleaner malfunctions.
LED Flashing Cause Solution
1 Flash
LEDashesonce
Floating cable may not be plugged
into the Control box correctly.
Unplugtheoatingcablefromthe
Control box and reconnect.
If the problem persists, contact
Baracuda Customer Service at
1300 784 423
2 Flashes
LEDashestwice
Cleaner wheels may be jammed
or brushes may be blocked with
debris.
Turn cleaner wheels to ensure
they are not jammed.
Check brushes for debris.
Start a new cleaning cycle.
If the problem persists, contact
Baracuda Customer Service at
1300 784 423.
3 Flashes
LEDashesthree
Pump axis or propeller may be
jammed with debris.
Dirtylter.
Check the pump axis for debris.
Check propeller for debris.
Cleanthelter.
Start a new cleaning cycle.
If the problem persists, contact
Baracuda Customer Service at
1300 784 423.
H670900_REVA 15