601–0443 /03 Balder12
- When the power cord or plug is damaged or frayed.
• Replacement parts: When replacement parts are required, be sure the service technician has used original
Barco replacement parts. Unauthorized substitutions may result in degraded performance and reliability,
fire, electric shock or other hazards. Unauthorized substitutions may void warranty.
• Safety check: Upon completion of any service or repairs to this projector, ask the service technician to
perform safety checks to determine that the product is in proper operating condition.
1.3 Projector Hazard Distances
WARNING. This may be a RG3 laser Product, dependent on which lens used.
This projector may become Risk Group 3 (RG3) when an interchangeable lens with throw ratio greater than
4.7 is installed. For Northern America, installation requirements according to Risk group 3 (RG3) must be
followed when interchangeable lens with throw ratio greater than 2.5 is installed. For the Cinemascope
variant, the projector can become RG 3 when a lens with throw ratio greater than 6.0 is installed.
Refer to the Installation Manual chapter 3, for the lens list and throw ratio before operation.
Do not look directly in to the beam from the projector lens.
No direct eye exposure to the beam is permitted.
Operators shall control access to the beam within the hazard distance or install the product at a height that will
prevent eye exposure within the hazard distance.
See “High Brightness Precautions”, page 49for a definition of hazardous distances versus the throw ratio of
the lens.
1.4 Safety symbols
Description of safety symbols used in product documentation or on product.
Image Description
Refer to user manual for further
information!
Caution! Do not stare into beam,
RG2 product.
No telephone! Do not connect to
telephone lines.
Balder Warning label
For North America, this projector may become RG3 when an interchangeable lens with throw ratio
greater than 2.5 is installed. Refer to the manual for the lens list and hazard distance before operation.
Such combinations of projector and lens are intended for professional use only, and are not intended
for consumer use.
This projector may become RG3 when an interchangeable lens with throw ratio greater than 4.7 is
installed. Refer to the manual for the lens list and hazard distance before operation. Such
combinations of projector and lens are intended for professional use only, and are not intended
for consumer use.
Ce projecteur peut devenir un projecteur RG3 en cas d'installation d'un objectif interchangeable
dont le r
apport de projection est supérieur à 4.7. Veuillez vous reporter au manuel pour en savoir
plus sur la liste des obje
ctifs et la distance de sécurité avant toute utilisation. De telles combinaisons
entre projecteur et objectif sont conçues pour des applications professionnelles uniquement et pas
pour des applications grand public.
Caution! For North America: With
interchangeable lens with throw ratio
greater than 2.5, consider hazard
distance and installation
requirements for RG3 product. See
“Risk Group 3 Safety”, page 47 , and
chapter “Lenses” in user manual
Caution! With Interchangeable lens
with throw ratio greater then 4.7,
consider hazard distance and
installation requirements for RG3
product. Refer User manual.
Balder Cinemascope Warning label Caution! For North America: With
interchangeable lens with throw ratio
greater than 6.0 , consider hazard
distance and installation
requirements for RG3 product. See
Safety
To Next Page
Loading...
Need help?
General
