R5911698 /07 Bragi12
• If the product does not operate normally when the operating instructions are followed. Adjust only those
controls that are covered by the operating instructions since improper adjustment of the other controls may
result in damage and will often require extensive work by a qualified technician to restore the product to
normal operation.
• If the product has been dropped or the cabinet has been damaged.
• If the product exhibits a distinct change in performance, indicating a need for service.
To prevent battery explosion
• Danger of explosion if battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the manufacturer.
• For disposal of used batteries, always consult federal, state, local and provincial hazardous waste disposal
rules and regulations to ensure proper disposal.
1.4 Safety symbols Bragi
Description of safety symbols used in product documentation or on product.
Image
Description
Refer to user manual for further
information!
Caution! Do not stare into beam,
RG2 product.
No telephone! Do not connect to
telephone lines.
This is a class A product. In a domestic environment this product
may cause radio Interference in which case the user may be
required to take adequate measures.
This device complies with part 15 of the FCC Rules, Operation is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003, / Cet appareil numerique
de Ia classe est conforme à Ia norme NMB-003 du Canada.
EMC:
FCC:
CANADA:
此為甲類資訊技術設備，於居住環境中使用時，可能會造 成射頻擾動，
在此種情況下，使用者會 被要求採取某些適當的對策。
警告使用者
RG2 IEC EN 62471-5
EMC Label
RG2 Label
Safety
To Next Page
Loading...
