27R5911698 /07 Bragi
Image 2–6
When all sensors are turned off, the projector will not receive any signals from the remote control. To
enable the sensors again, use the keypad on the projector.
Select which sensors to be disabled.
Image 2–7
Enter the Apply button to confirm the action
2.8.7 Wired RC connection
About
The remote control can also be directly wired to the projector from the stereo jack connector on the remote,
(See “Functionality overview”, page 25 ), to the RC connector on the back panel of the projector.(See section
“Connector Panel”)
In this mode, the projector will not be affected by signals from other non-wired remote controls.
When using wired remote control, the broadcast address must be set to “Generic ID (0)”. See the menu in
“Enable / Disable Remote Control”, page 26.
It is not possible to program the remote control in wired mode. (Directly connected, no sense in programming).
2.9 Projector Address
Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.
Getting to know the projector.
To Next Page
Loading...
