R5900120 /03 ClickShare CX-50 Gen222
2.3 Basic Workflow
Before using CX-50 Gen2
1. Unpack the ClickShare components and accessories from the box.
For a detailed overview of the content of the CX-50 Gen2 box, see
“About the Base Unit”, page 14.
2. Install the Base Unit in the meeting room using one of the 2 possible installation methods.
For more information on the installing procedures, see
“Installation methods for the Base Unit”, page 24
3. Connect the display with the the Base Unit via HDMI or the backside USB Type-C
TM
port, see
“Display
connection to the Base Unit”, page 36
.
4. Connect the audio devices via USB or jack, if any to the Base Unit, see “Fully equipped, Audio only or
Camera only conference room”, page 38
or “Content Audio connection”, page 44.
5. Connect the USB camera to Base Unit if any, see “Fully equipped, Audio only or Camera only conference
room”, page 38
or “Camera connection”, page 43.
6. Make the power connection via the power adapter or the backside USB Type-C
TM
port, see
“Power
connection”, page 48
.
7. Connect a network cable between the Base Unit and the local network (make sure the Base Unit is
connected to the internet to be able to reach the update server )
8. Configure device.
9. Register you device online to obtain your SmartCare package.
10. Pair your Buttons, see “Preparing the Buttons”, page 67 and/or install the ClickShare app.
Getting started
To Next Page
Loading...
