7. Important information
ChinaEnergyLabel
If there is a China Energy Label on your packaging or product, the product meets the following energy
requirements corresponding with the energy efficiency level on the label.
按照中国 << 能源效率标识管理办
法>>
In accordance with The Regulation
of the Implementation on China
Energy Label
本显示器符合以下要求
This monitor is compliant with the
following requirements
本显示器符合以下要求
This monitor is compliant with the
following requirements
能源效率等级
Energy Efficiency Level
12
能源效率
Energy Efficiency (cd/W)
>1.05 >0.85
关闭状态能耗
Energy Consumption in off mode
(W)
<0.5 <1.0
执行的能源效率国家标准编号
Code of National Standard applied
GB 21520 GB 21520
7.3 Regulatory compliance information
Indications for use
This display is an AMLCD display designed for viewing X-ray images by professional physician for infant
or adults for reference purpose. This unit should not be used near patients (where patients are likely to
be in unconscious condition) and should be kept outside of 1.83 m perimeter and 2.29 m vertical.
FCC class B
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Canadian notice
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
K5903081 EONIS 08/03/2016
27
To Next Page
Loading...
