Barco Eonis MDRC-2224 - Display Installation; Adjusting the Display Position; Removing the Cover

3. Display installation
3. DISPLAY INSTALLATION
3.1 Adjusting th e disp lay po sition
To adjust t he display position
You can now safely pivot, tilt, swivel, raise and lower your display as desired.
Image 3-1
The standard orientation of the video input is landscape. If you use the display i n portrait
mode, make sure you change the orientation of the v ideo input via the screen settings
of the computer.
WARNING: The display must be in its highest position before it can be properly pivoted.
3.2 R emoving t he cover
To remove the connector compartment cover
The connector compartment cover should be removed to get access to the connectors. To remove the
cover, gently slide the connector compartment cover upwards and remove it from the display.
K5903081 EONIS 08/03/2016
7