2. General
Image 2-4
ICMP battery slot with cover
1ICMP
2 Tamper evident sticker
3 Battery in his slot (under the cover)
4 Cover
5 Insertion date stickers
6 Tamper evident sticker
Batterylifetime
An electric battery is a device is based on electrochemical cells that converts stored chemical energy into
electrical energy. Over time, the degradation of these elements causes a discharge of the battery. It is
necessary to change the battery every 5 years to ensure proper operation of the ICMP.
The insertion date (MM/YY) is write on a label positioned on the top of the battery cover.
During an inspection, if you see that the indicated date is more than 4 years, the battery
should be changed as soon as possible.
Electric and electrostatic recommendations
The ICMP card is sensitive to electrical short-circuits. During the replacement procedure, be very careful
not to touch the two connectors (positive / negative) in the battery slot with the battery or any other metallic
objects. A short circuit between the two connectors would cause immediate failure of the card.
Image 2-5
After removing the ICMP assembly from the projector, it is recommended to put it on clear, stable and
insulated support during all
the battery replacement procedure, to avoid any accidental short-circuit.
CAUTION: Wear insulating gloves during the execution of the procedure to avoid short-
circuit.
R5906594 ICMP 09/11/2016 11
To Next Page
Loading...
Need help?
General