2. Unpacking and installation
2.4.1.2 Inputs
On the rear, all interfaces are located as well as the exchangeable AC power module and the power connector.
The AC power module can be exchanged by a DC power adapter which allows connecting to the DC power supply
over distances to up to 100m without performance loss.
Safety instruction on opening systems built into a structure
OPS OPS Open pluggable specification channel with HDCP 1.4
DVI 1, DVI 2 DVI single link input with HDCP 1.4, up to 165 MHz)
HDMI HDMI 1.4a with HDCP 1.4, up to 300 MHz
DP DisplayPort input with HDCP 1.3, up to 300MHz
DP DisplayPort output with HDCP 1.4
S/PDIF Audio output interface according Sony/Philips Digital Interface specification
LAN 1, LAN 2 1 GB Ethernet input, video streaming supported.
USB USB interface USB 2.0
All inputs (OPS, DVI 1, DVI 2, HDMI, DisplayPort) have a loop-through connection to DisplayPort out (loop-through
connection is established as soon as the input is the active input).
The displays feature push buttons for some basic commands.
Currently 3 push buttons are supported: Power, Source, Menu
Power Press < 5sec to switch device from on to idle and vice versa (system with AC/DC Power supply)
Press > 5sec to bring the device to low power standby; when in low power standby, press <5sec to
start the display booting and showing the configured input source (system with AC/DC Power sup-
ply)
Menu Press <2sec to show the IP address of the device. Pressing it again goes back to last shown input
source.
Source Press <2sec to scroll the selected input to DVI1->DVI2->HDMI->DP->OPS->DVI1 …
32
_____________________________________________________________
Barco - KVD5521, IVD5521, HVD5521 - R591341 - User Manual - Revision 05 - November 2016
To Next Page
Loading...
