13. Troubleshooting
13 Troubleshooting
When faults occur which are not described below please contact Barco.
13.1 Faults
Faults cause/steps
No picture Make sure that the power cord is plugged into the wall out
Make sure that the display is not in off
Check if the signal cables are properly connected to the dis-
play and to the signal source
Check if the input setting is correct
Check if the signal is suitable.
The display can not be controlled via the
IR RCU
Make sure that the batteries are inserted correctly (matching
the + and – marks of the battery compartment)
Replace the batteries.
Point the front of the RCU directly to the sensor.
Is the senor properly connected?
The remote control unit will not function properly if strong
light strikes the sensor window or if there are obstacles be-
tween the remote control unit and the IR sensor.
Barco - KVD5521, IVD5521, HVD5521 - R591341 - User Manual - Revision 05 - November 2016
_______________________________________________________
81
To Next Page
Loading...
