Overview
11
Parts, controls and connectors
Front
Figure 1
1. Ambient Light (ALC) sensor. When ALC is switched on, the display
light output is adapted automatically, depending on the ambient
light measured by the sensor.
2. Power LED
The LED is off when the display is disconnected from the power.
The LED is also off when the LED function is disabled in the on-
screen display (OSD).
The LED is green when the display is on (when enabled in the on-
screen menus).
The LED is orange when the display is in Stand-by power-saving
mode.
3. Control wheel
The control wheel can be pressed like a push button and rotated
like a knob.
It allows to put the display in stand-by, navigate through the on-
screen display (OSD) menus and change values in the OSD.
c d
e
To Next Page
Loading...
