Barco MVGD 1318 CR/ER - Page 44

Operation
44
• switch the display in stand-by mode
To disable user controls:
1. When the OSD is not on the screen, rotate the control wheel to
display the Extended OSD. The Main Menu appears.
2. Rotate the control wheel to select Exit.
3. Press and hold the control wheel until the Advanced Main Menu
appears. This is indicated by an asterisk (*) in the menu header.
4. Rotate the control wheel to select Settings.
5. Press the control wheel to enter the Settings menu.
6. Rotate the control wheel to select User Controls.
7. Press the control wheel to disable the setting. This is indicated by a
cross in the menu.
8. Exit the menus and save the changes.
To enable user controls again:
1. Remove power from the display so that the display is completely
off. This is not the Stand-By mode. The power LED must be off.
2. Press and hold the control wheel. Then power up the display
again. Release the control wheel after 2 seconds.
3. When the display has started up, rotate the control wheel. The
Extended OSD appears.
4. Enter the Advanced menu mode and enter the Settings menu.
5. Enable User Controls again.
6. Exit the menus and save the changes.