Operation
42
User Controls
When you disable this setting and exit the OSD, some functions of the
control wheel are disabled.
Please refer to the chapter about locking and unlocking user controls, to
know how to use this function.
Name Description
RGB->RGB The R video signal drives the R sub-pix-
els, the G video signal drives the G sub-
pixels and the B video signal drives the
B sub-pixels. This is the preferred set-
ting for color display controllers.
RGB->Y The RGB video signals from the imaging
board are calculated and transformed
into a single luminance value according
to the formula 0.3R + 0.59G + 0.11B.
This single luminance signal drives the
RGB sub-pixels of the panel equally.
Use this setting in case the imaging
board is a color board and if the signal
must be displayed in monochrome.
R->Y The Red video signal from the imaging
board is used as luminance value to
drive the RGB subpixels of the panel
equally.
G->Y The Green video signal from the imag-
ing board is used as luminance value to
drive the RGB subpixels of the panel
equally.
B->Y The Blue video signal from the imaging
board is used as luminance value to
drive the RGB subpixels of the panel
equally.
To Next Page
Loading...
