Barco NIO 5MP - Page 31

Display Controller installation
31
connect the secondary display to the other connector on the
display controller.
7. Reconnect the power cord, turn on the power, and boot the system
as usual.
Running multiple BarcoMed Nio Display Controllers in a single host
The physical order of the displays may vary when you are running
multiple BarcoMed
Nio display controllers. This is due to the PC’s PCI bus
control in the system BIOS, and not the BarcoMed display controller. It
may become necessary, depending on how your PC’s BIOS configures
the PCI bus, to switch your DVI display connections to achieve a linear
desktop configuration.
Figure 7