Display operation
62
3. Press the control wheel to enter the Settings menu.
Figure 27: Settings menu
4. Rotate the control wheel to select User Controls.
5. Press the control wheel to switch from “On” to “Off”.
6. Exit the menus.
To enable user controls:
1. Make sure the on-screen display is not on the screen.
2. Do not use the control wheel for at least 3 seconds.
3. Rotate the control wheel 1 step clockwise.
4. Press the control wheel 2 times.
5. Rotate the control wheel 1 step counterclockwise. The on-screen
display appears.
Note: Steps 2 to 4 must be performed in maximum 3 seconds.
6. Rotate the control wheel to select Settings.
7. Press the control wheel to enter the Settings menu.
Figure 28: Settings menu
8. Rotate the control wheel to select User Controls.
9. Press the control wheel to switch from “Off” to “On”.
10. Exit the menus.
SETTINGS
DPMS On
Power LED On
User Controls On
EXIT
SETTINGS
DPMS On
Power LED On
User Controls Off
EXIT
To Next Page
Loading...
