Barco NIO 5MP - Page 79

Troubleshooting
79
Uninstalling the BarcoMed Nio driver
1. Insert your BarcoMed
Nio Software CD into your computer’s CD
drive.
2. The BarcoMed Product Installation Wizard will display its welcome
screen.
3. Make certain that the checkbox next to the driver is checked and
that all other checkboxes are unchecked (figure 31). Click “Install”
to continue.
Figure 31
4. Click “Next”.
5. On the next screen (see figure 32 on page 80), check the checkbox
next to “Uninstall this device” and click “Next” to continue.