3. Operation
• Gamma 1.8 or 2.2: Select one of these display functions in case the display is to replace a CRT display
with a gamma of 1.8 or 2.2 respectively.
• QAWeb: This setting is automatically selected when the display function is determined by Barco’s
MediCal QAWeb application. Manually selecting the QAWe b display function is not recommended.
The settings of the display must be adapted t o suit the requirements of the visualization
software. In case of doubt, please contact the vendor of the visualization software.
To select a display fu nction
1. Bring up the OSD main menu.
2. Navigate to the Adjustments > Display function menu.
3. Select one of the available display functions and confirm.
3.9 W hite point selection
White point selection is disabled when sRGB is selected in the Adjustments menu.
About white point selection
This setting allows you to modify the display white point, used as reference for all other colors to be dis-
played.
The available white point settings for your display are:
• Native: The native, unmodified color temperature of the LCD panel.
• 6500K: Corresponds to a color temperature of 6500 Kelvin (D65).
• 7500K: Corresponds to a color temperature of 7500 Kelvin (D75).
To select the white point
1. Bring up the OSD main menu.
2. Navigate to the Adjustments > White point menu.
3. Select one of the available white point presets.
3.10 Power save mode
About power save mode
Enabling power save mode on your Nio Color 2MP 23" will optimize the display lifetime by automatically
switching off the backlight when no video signal is detected after approximately 10 seconds.
To enable/disable power save m ode
1. Bring up the OSD main menu.
2. Navigate to the Adjustments > Settings menu.
3. Enter the Power save submenu.
4. Select On or Off as desired and confirm.
16
K5902134 NIO COLOR 2MP 23" 05/07/2017
To Next Page
Loading...
Need help?
General
