General tips
64 Nio display systems
Setting the resolution of your Nio display
Note: In order to set the resolution of your Nio display you must
be logged in using an account with administrator privileges.
1. Open the “Windows Display Control Panel” by one of the two
methods below:
a) Start > Settings > Control Panel > Display
or
b) Open the “Display Properties Control Panel” by right
clicking in an empty area on the desktop, then select
Properties.
2. Click on the Settings tab.
3. Select the rectangle that represents the Barco Nio display whose
settings you wish to change.
Note: If you are using the VGA capabilities of your BarcoMed N
IO
display controller, the resolution for the first display may be set to
a VGA resolution of “640 x 480” pixels with 16 colors and a default
refresh rate. If your BarcoMed N
IO controller is not running VGA,
the display may not be enabled yet. To enable the display, check
the “Extend my Windows desktop onto this monitor” checkbox,
but do NOT click the Apply button at this time.
If you installed your B
ARCO NIODisplay System drivers in SingleView
mode (default for Windows 2000) there will be one rectangle for
the virtual display representing the two heads controlled by each
BarcoMed N
IO display controller.
If you installed your B
ARCO NIODisplay System drivers in DualView
mode (default for Windows XP) there will be a rectangle
representing each head controlled by each BarcoMed N
IO display
controller. This will be true even if you have only one display
connected to your BarcoMed N
IO controller. Both displays of a
display controller cannot be enabled at the same time unless their
display properties match. If necessary detach the second display of
the BarcoMed N
IO display controller you are working with by right
To Next Page
Loading...
