Installing your Barco display controller
24 Nio display systems
Installing your Barco display controller
This chapter will guide you through the physical installation of the
display controller(s) for your B
ARCO NIO Display System.
Overview
Prior to installing the display controller(s) for your BARCO NIO Display
System in your PC please take a few minutes to familiarize yourself with
both the display controller(s) and the PCIe slots in your computer.
Types of display controllers for Nio Display Systems
There are four different models of display controllers available for your
B
ARCO NIODisplay System.
If you are using the BARCOMED PCIe display controller, you will need to
decide if you are going to use its on-board VGA capabilities. If you are,
check the setting of the Jumper at J-1 on the display controller (see
figure 4). By default, VGA should be enabled, on the top two pins. To
disable the on-board VGA capabilities of you B
ARCOMED PCIe display
controller move the jumper so that it is on the middle and bottom pins.
Figure 4: BARCOMED PCIe display controller VGA Jumper, VGA enabled
CAUTION – Wear a grounded, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
Board Model VGA Jumper Recommended PCIe Slot
B
ARCO MXRT 2100 No x16
B
ARCO MXRT 5100 No x16
B
ARCO MXRT 7100 No x16
B
ARCOMED PCIe Yes x8
To Next Page
Loading...
