Barco R9040100 - Projector Configurations

2-2
Installation Guidelines
5976135 BARCOSIM 6 21032000
Projector Configurations
Which configuration can be used ?
The projector can be installed to project images in four different configurations :
Front/table
Rear/table
Front/ceiling or
Rear/ceiling
)URQW7DEOH
)URQW&HLOLQJ
5HDU7DEOH
5HDU&HLOLQJ
Positioning the Projector
Drawing are given for a nominal lens position.
Definitions of the Abbreviation on drawings
B = Distance between ceiling and top of the screen or between floor and bottom of the screen.
A = Correction value, distance between bottom side of projector (without feet) and middle of the lens. Value to be subtracted from
B to obtain the correct installation position. (A value is a constant value for all screen widths and type of lenses, A = 124.1 mm or
4.89 inch)
CD = Total distance between projector and ceiling or projector and floor.
SW = Screen width.
SH = Screen height (image height).
PD = Projector Distance, distance between screen and projector.