Barco R9040100 - Configuration; OSD Color (On-Screen Display); Internal Patterns

8-3
Installation Mode
5976135 BARCOREALITY SIM6 21032000
Internal Patterns
What can be done with these internal patterns ?
The projector is equipped with different internal patterns which can be used for measurment purposes.
Configuration
What can be done ?
The way of physical installation of the projector can be defined to the projector.
The following installation configurations are possible :
- front/table
- front/ceiling
- rear/ceiling
- rear/table
Set up the Correct Configuration
1 Push the cursor key é or ê to highlight 'Configuration' (menu 1).
2 Press ENTER to select.
The Configuration menu will be displayed.
For more information, see Projector configuration in chapter 3 : 'Installation Guidelines'.
OSD color (On-Screen Display)
What can be done ?
The highlighted items on the menus can be displayed in red, green or yellow.
How to change this color setting ?
1 Push the cursor key é or ê to highlight 'OSD color'.
2 Press ENTER to select.
The OSD color menu will be displayed.
3 Push the cursor key é or ê to highlight a color.
4 Press ENTER to select.
OSD COLOR
HIGHLIGHTED ITEM
RED
GREEN
YELLOW
Select with é or ê
then <ENTER>
<EXIT> to return.
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
INSTALLATION
INPUT SLOTS
800 PERIPHERALS
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
MENU POSITION
QUICK ACCESS KEYS
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
INSTALLATION
INPUT SLOTS
800 PERIPHERALS
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
MENU POSITION
QUICK ACCESS KEYS
menu 2