Barco R9040100 - Common Address; Projector Address

Service Mode
9-5
5976069 BARCOREALITY SIM6 21032000
Select with é or ê
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
DIMMING
MORE ...
menu 1
menu 2
Start up
1 Push the cursor key é or ê to highlight 'Change Projector Address'' (menu 1).
2 Press ENTER to select.
The Change Projector Address menu will be displayed.
Projector Address
How to change that address ?
1 Push the cursor key é or ê to highlight 'Projector Address'' (menu 1).
2 Press ENTER to select.
The actual address is filled in.
The first digit is highlighted.
CHANGE PROJ. ADDRESS
Projector address : 1
Common address (RC5) : 0
Common address (PPM) : 0
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
CHANGE PROJ. ADDRESS
Projector address : 1
Common address (RC5) : 0
Common address (PPM) : 0
Select with é or ê
then <ENTER>
<EXIT> to return.
Entering the new projector address
- with the digit keys on the RCU or the local keypad or
- push the cursor key ç or è to select a digit and change the value by pushing the cursor key é or ê until the new value is reached.
Continue with the other digits on the same way.
Common Address
How to change that common address ?
1 Push the cursor key é or ê to highlight the active 'Common Address'' (menu 1).
2 Press ENTER to select.
menu 1
Select with é or ê
then <ENTER>
<EXIT> to return.
CHANGE PROJ. ADDRESS
Projector address : 1
Common address (RC5) : 0
Common address (PPM) : 0
Entering the new common address
Only addresses between 0 and 1 are valid.
- with the digit keys on the RCU or the local keypad or
- pushing the cursor key é or ê until the new value is reached.