8-2
Installation Mode
5976135 BARCOREALITY SIM6 21032000
800 PERIPHERAL
Possible results for the input slots :
Source indication
Video or S-Video Video
S-Video
RGB analog RGB-CV : separate sync is composite video signal on H/C input
RGB-HS&VS : separate sync is horizontal and vertical sync
RGB-CS : separate sync is composite sync
RGB-SOG : sync on green
Component video Component Video
What if a switcher is connected to the projector ?
If a RCVDS (switched on) or VS05 is connected to the projector, it will be also indicated on the menu by adding
+800 peripheral
. If
no 800 peripheral indication is made on the menu, there are still two possibilities :
- no RCVDS or VS05 connected or
- RCVDS is switched off.
When a 800 peripheral is connected to the projector, the input slots are not accessible with the cursor key to toggle their function.
800 Peripheral
What can be installed ?
- The type of output module in a RCVDS05.
- The type of communication protocol.
Defining the Output module of the RCVDS05
When a RCVDS05 is connected to the projector, the type of output module of this RCVDS05 has to be defined in the 800 peripheral
menu.
The type of output module can be :
- standard output module or
- 5 cable output module.
To define the output module :
1 Push the cursor key é or ê to highlight '800 Peripheral' (menu 1).
2 Press ENTER to select.
3 Push the cursor key é or ê to highlight 'Output module' (menu 2).
4 Press ENTER to toggle between 'Standard' or '5-cable'.
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
OUTPUT MODULE [STANDARD]
INFRARED [PPM]
INSTALLATION
INPUT SLOTS
800 PERIPHERALS
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
MENU POSITION
QUICK ACCESS KEYS
Defining the Infrared Communication protocol
When a peripheral is connected to the 'Comm Port', the communication can be in PPM or RC5.
The type of communication can be set to :
- PPM
- RC5
To define the communication :
1 Push the cursor key é or ê to highlight 'Infrared' (menu 1).
2 Press ENTER to select.
3. Press ENTER to toggle between [PPM] or [RC5].
800 PERIPHERAL
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
OUTPUT MODULE [STANDARD]
INFRARED [PPM]
INSTALLATION
INPUT SLOTS
800 PERIPHERALS
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
MENU POSITION
QUICK ACCESS KEYS
To Next Page
Loading...
