Barco RHDM-2301 - Page 213

Barco - RHDM-2301 - User manual 213
Addendum
IMPORTANT :
The display unit is wider than the opening of a 19 inch rack and will be mounted partly in front of the 19 inch rack.
NOTE :
The display unit can be installed in a 19 inch rack without the control panel mounted at the bottom. In order to be
able to operate the display unit, a connection to a control panel needs to be provided.
Instructions to mount the display unit in a 19 inch rack:
• Mount the rack brackets to each side of the 19 inch rack. Verify if both rack brackets have been
mounted at the same height.
• Mount the cover bracket to the 19 inch rack.
• Mount the bolts to the display unit at the dedicated spots (see figures).
• Hang the display unit into the rack brackets mounted onto the 19 inch rack. Verify if all neces-
sary cables have been connected before installing the display unit in the rack.
• Tighten the bolts to the rack to secure the display unit in the rack.
CAUTION :
The cover bracket is necessary to allow sufficient ventilation of the display unit.