25R5911443 /03 UDM
Image 2–3
9 IR receiver projector rear side
10 Mains power input socket (for
C19 plug)
11 Power ON/OFF switch
12 Overvoltage status light
13 USB port (to control
motorized rigging frame)
For detailed info about the Input & Communication module see chapter “Input & Communication”, page 39.
Projector airflow
The projector has three air inlets: one at the top, one at the front and one at the right side of the projector.
Each air inlet is equipped with a dust filter. For cleaning/replacement instructions see chapter “Product
maintenance”, page 155.
There is only one air outlet which is located at the rear of the projector.
Image 2–4
CAUTION: Keep the air inlets and outlet at all times free. Make sure there is a
minimum distance of 40 cm (15.7 in) between the air outlet and the nearest solid object.
Projector Infra Red receivers and Remote Controle Unit
The projector has three Infra Red receivers: one at the rear (next to the power input), one at the front (below
the lens holder) and one at the right side (integrated in the Input & Communication module).
Point the Remote Controle Unit (RCU) directly to the Infra Red (IR) receiver. Make sure you are within the
effective operating distance (30 m, 100 ft in a straight line)
The RCU will not function properly if strong light strikes the IR sensor window or if there are obstacles
between the RCU and the IR sensor.
Getting Started
To Next Page
Loading...
