99R5911443 /03 UDM
From the start (mask) position, you can blend zone size per edge (left, top, right, bottom). For each edge there
will be a drop-off curve for the blend zone.
8.11.1 Basic blend
How to set up a basic blend zone?
1. In the main menu, select Installation → Blend and Mask → Basic blend.
Image 8–55 Blend menu, Basic blend
The Basic blend menu is displayed.
Image 8–56 Example of the basic blend menu
2. To enable blending, put the Enable switch to the right. The color of the switch becomes blue when
enabled.
3. To project masking lines on the screen, put the Show lines switch to the right. The color of the switch
becomes blue when enabled.
4. Determine the start position of the blend area height and width to determine the dimension of the blend
zone.
When the helping lines are activated, you will get a visual indication of the screen of the installed blending
area.
GUI – Installation
To Next Page
Loading...
