R5911443 /03 UDM90
The 4 corners menu is displayed.
Image 8–32 Example of the 4 corners menu
2. To enable 4 Corners warping, enable the 4 corners slider.
3. To have a visual representation of what your warp will look like, enable the Helper lines slider.
Image 8–33 Example of 4 corners warping menu, with helper lines active on the edges of the screen
4. To set warping on one of the four corners, select one of the four corners and confirm.
5. Set the desired X and Y coordinates for this corner, using the arrow keys, and confirm.
After confirming, the helper lines for that corner will jump to the entered XY coordinate (if helper lines were
enabled).
GUI – Installation
To Next Page
Loading...
