Operation
Proceed as following to bleed the heating cushions:
► Pull the left-hand top tube out of the push-fit connector so that the water can rise in
the water ducts.
► Wait for around 5 seconds. Now re-connect the tube to the push-fit connector.
► First, start a program without any product to heat.
► If the pump does not immediately pump heat transfer fluid into the cushions, stop the
program and start it again after waiting for a short time. If necessary, repeat the start
and stop operations a few times until the pump starts pumping fluid.
► Once the heating cushions have been filled, open the cover of the heating chamber.
► Squeeze out any air bubbles present in the cushions with your hands, pressing to-
wards the right-hand tube connection. Any bubbles removed can be heard as a gur-
gling sound.
► Close the cover so that the heating cushions fill up again.
► If there are still significant amounts of air in the heating cushions, the process must be
repeated.
Small bubbles disappear once the heat transfer liquid has been warmed up.
To Next Page
Loading...
