Operation
If a "Lack of water" message as described in the Chapter Messages after the end of a pro-
gram is acknowledged 4 times at the end of a program without water being topped up,
then an active program will be immediately cancelled the next time low water is detected.
► Switch off the device.
► Switch the device on again.
► Top up with water as described in
Chapter 5.3.2
Figure 19: Message "Lack of water!"
4.4.5 Messages after the end of a program
When the heating duration has elapsed, the flashing message "Program complete" appears
and an intermittent signal sounds. This indicates that the program has finished and pre-
vents inadvertent further heating.
► Open the heating chamber cover
or
► Acknowledge the end of the program
with the confirm button ("OK")
Figure 20: Program complete
If a lack of water was previously detected while the program was running, then another
message is displayed when the "Program complete" message is acknowledged.
As well as an appropriate on-screen message being displayed, an intermittent acoustic
signal is sounded. This will be a rapid sequence of pulses to distinguish the signal from
the signal that indicates the normal end of a program. Here again, the message must be
acknowledged by pressing the confirm button ("OK").
P r o g ra m c om p l e t e
OK
L a c k o f wa t e r !
F I L L t a n k
S w i t c h o f f t h e
device
To Next Page
Loading...
