Bartec Pro Series User Manual

Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 18
2.3.2 Magnet Activation
If the procedure requires a magnet, the tool will instruct
the user to “Place magnet on stem”.
Place the magnet from your PRO Series kit over the valve
stem, position the tool alongside the stem, and press the
Test key.
2.3.3 ∆p (Lowering Pressure) Activation
If the sensor requires tire deflation (minimum of 10psi),
the tool will instruct the user to “Reduce Pressure”.
Position the tool alongside the valve stem. Begin releasing
air from the tire accordingly (this is easiest when using an
approved tool to press the valve core), and press the Test
key on the tool.
NOTE:
If the tool fails to read on the first try, continue
releasing air pressure and press Test again.
Begin reducing
pressure, then
press Test

Bartec Pro Series Specifications

General

Brand	Bartec
Model	Pro Series
Category	Diagnostic Equipment
Language	English