43
5.2 Status
This page displays information about the SB. The page is updated automatically.
• ID contains:
o Name of the MR3000SB (by default this is mr3000, followed by a dash and its serial
number). You may change the name, according to your needs (see Section 5.4.1).
o Comment, for example a description of the location where you have installed the SB.
This text is shown together with the name in the messages (see Section 5.4.1).
o UID unit ID (serial number) – can not be changed
o firmware version.
Sensor tells you for which sensor the SB is configured.
Activity reports the current activity of the data acquisition services:
o Trigger shows 3 different states:
idle: the SB is not recording an event
recording: the SB is currently recording an event
triggering: one of the trigger conditions is fulfilled and the SB is recording until the
post-event time is elapsed.
o Background: this shows if the SB is currently recording a peak file (file name) or not
(idle).
o FTP backup: shows 4 different states:
in progress: currently a file is sent to the FTP server.
errors: errors occurred when communicating to the FTP server.
idle: service is active, but there is no new file to be copied.
disabled: service is not active.
o FTP push: shows 4 different states:
Pushing N files: after starting the service the number of files to be sent is shown.
N files pending: N files are waiting to be sent in case of trouble or many files have
been recorded recently and have not been transferred yet, eg. due to slow
communication.
idle: service is active, but no scheduled push is currently going on.
disabled: service is not active.
o Timed recordings: shows 3 different states:
active: the SB is either recording (see trigger status above) or in the period
between two scheduled recordings.
idle: service is active, but start time has not been reached yet.
disabled: service is not active.
LAN displays the IP address of the SB on the Ethernet port or FO, and the MAC address of
the interface.
To Next Page
Loading...
Need help?
General
