SURFACE PREPARATION SYSTEM OWNER’S MANUAL & PARTS BOOK
BARTELL MORRISON INC. BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
25 INDUSTRIAL DRIVE, KEYPORT, NEW JERSEY, USA, 07735, 732-566-5400 FAX 732-566-5444
- 14 -
CHANGING CUTTERS/SHAFTS
Once the cage has been removed use a 5/32” Allen Key
and 7/16” open end wrench, remove screws and cover
plate from cage. With drift pin tap rods from the drive side
until free of cage. Replace cutters or shafts as required.
Replace cover plate. To re-install cutter cage in machine,
reverse procedure for removal. Ensure that the shaft is
tight.
STORAGE - Before
The following steps should be taken to prepare your SPS
gas unit for extended storage.
1. Close fuel shut off valve.
2. Remove excess gasoline from tank.
3. Start engine until it stops from lack of fuel. This will
use up all the fuel in the carburetor and prevent
formation of deposits due to evaporation of fuel.
4. Remove spark plug and pour 2 oz. of SAE-30 or SAE-
40 motor oil into the cylinder. Slowly crank the engine
2 or 3 times to distribute the oil throughout the
cylinder. This will help prevent rust during storage.
Replace spark plug.
5. Store the unit in an upright position in a cool, dry, well
ventilated area.
6BSTORAGE - After
The following steps are recommended to ensure a
smooth, proper startup after a prolonged storage.
1. Refuel
2. Open shut off valve
3. Start engine. Any excess oil residue will quickly burn
off without harming operation.
7BLUBRICATION
ENGINE OIL
Always check engine oil before starting and at
regular intervals thereafter. Use proper engine oil as
recommended – see chart below. Keep engine oil
clean, change accordingly. Fill crankcase to levels
as recommended in manufacturer’s engine manual.
Season Temperature Grade of Engine Oil
All Seasons SAE 10W-30
To Next Page
Loading...