Basic American Zenith 7000 - Plugging in the Optional Footboard Staff Control; Attaching the Footboard; Connecting Your Cables

PLUGGING IN THE OPTIONAL FOOTBOARD STAFF CONTROL
Staff Control
Assembly
Shroud
(Cable Cover)
Cable Tie
Staff Control
Cables to right
Mounting Tube
Phillips Screws
attach Shroud
& Staff Control
Assembly from
inside of board
Footboard
with cutout
Male end of Staff Control Assembly
Cable - plugs into short Black
Control Cable
Female end of Staff Control
Assembly Cable - plugs into T-Cable
Loop Male Staff Control Cable
and cable tie through mounting
tube hole with Female Staff
Control Cable
Short Black Control Cable
running from Control Box
End of T-Cable at foot end - GREY
(“T” runs on either side of Seat Pan
for attaching your Hand Controller)
DETAIL B:
MAKE SURE LOCK END
CAPS ARE SCREWED
ON SECURELY
SEE PAGE 9 OF THIS
MANUAL FOR PROPER
ASSEMBLY OF ELBOW
MOUNTING BRACKET
(TUBES) & FOOTBOARD
FOOT
END
DETAIL A:
CLOSEUP OF
STAFF CONTROL
CABLE CONNECTION
Basic American Medical Products, a division of GF Health Products, Inc. www.grahamfield.com 999-0843-190A Service Manual
10
STEP 1 - ATTACHING THE FOOTBOARD:
You can order an optional Staff Control for the Zenith 7000 which
includes a Staff Control Assembly and Shroud Cover pre-installed
to the Footboard at the manufacturing factory.
To attach the Footboard assembly (with Staff
Control) to the main frame rails, please see
the instructions on PAGE 9 of this manual.
STEP 2 - CONNECTING YOUR CABLES:
Please refer to DETAIL A shown below.
• At the foot end, unplug the Black Staff Control
cable from the end of the Grey T-Cable.
(Cables were attached for shipping)
• Insert the phone jack plug on the male end
of the staff control cableinto the cylindrical
plug of the Black Control Cable that extends
out the foot end. Make sure the phone jack
is positioned properly inside the cable.
• Insert the T-Cable end (
extending out the
foot end with phone jack ) into the cylindrical
plug of the female staff control cable.
Make sure the phone plug is seated
properly inside the female plug.
• Screw on the round lock cap onto
the Staff Control female plug and
short Black Control Cable plug.
(SEE DETAIL B)
ZENITH SERIES