Configuring the Camera
54 Basler IP Camera
Occasionally, firmware updates may be made available to the field. The Start
Firmware Update button is used to start the firmware update process.
To determine the version of the firmware currently in your camera, access the
Info tab (see page 48).
To see if a new firmware version is available, go to our website:
www.basler-ipcam.com
If newer firmware is available, download it to your computer. Note that the
firmware is different for each camera model, so be sure to download the
appropriate firmware for your model.
If you have downloaded a new firmware update file from the website, you can
update the firmware in your camera by following this procedure:
1. Click the Start Firmware Update button.
2. A Firmware Upload dialog box will open as shown below. Click the
Browse button in the dialog box.
If you are updating from version 1.2-0 firmware or below, the
network settings currently in the camera will be lost when you
do the update. The camera will revert to the default network
settings when the update is complete. In this situation you must
use the BIP finder software to locate your camera on the
network after the update is done, and you must use the Basler
Surveillance Web Client to reset your network settings as you
desire.
Once you have installed version 1.3-0 firmware or higher on
your camera, this behavior will be changed and the camera will
retain its network settings during an update.
To Next Page
Loading...
Need help?
General
