33
Oven
he purpose of this feature is to facilitate the removal of food and
gre
o
cleaning cycle may overflow.
o nsures a perfect seal
between the tube located in the jug and the hydraulic circuit
o ).
cavity cleaning cycle
T
ase from the oven cavity after cooking.
Fill the water jug with distilled water, or if this is unavailable cold
drinking water.
o Fill the water jug up to the 1.2 l mark. DO NOT fill the jug right
to the top. Otherwise the water that is pumped back into the jug
at the end of the
o Insert the jug into the water jug compartment.
Push the jug down completely, this e
inside of the oven.
Switch the oven on using the oven ON/OFF button (6
SELECT COOKING MENU will appear on the display.
o Use the oven setting selection buttons (9) until SETTINGS
appears on the display. Press the confirmation button (8) to
confirm your choice.
ction buttons (9) until START THE
CLEANING CYCLE appears on the display. Press the confirmation
o Use the oven setting selection buttons (9) until COOKING
our choice.
l
o When the cleaning cycle is finished, use a damp soft cloth or
ity of the oven.
The purpose of this feature is to remove any limescale that may have
uilt u r.
er in t
ilding in
the first place.
o Use the oven setting sele
button (8) to confirm your choice.
CHAMBER appears on the display. Press the confirmation button
(8) to confirm y
o Follow the instructions that appear on the display. The cavity wil
be filled with a quantity of steam for approximately 10 minutes.
damp non-abrasive sponge to wipe over the cav
Boiler descaling
p in the steam boileb
o IMPORTANT: We recommend that you use distilled wat he
water jug, this will minimise the chances of limescale bu
To Next Page
Loading...
