Baumatic P470SS - My Appliance Isnt Working Correctly

42
y appliance isn’t working correctly M
Error codes chart
Error
code
Cause Solution
ERR
001
BOILER OVERHEAT
This alarm is caused by the fill
pump being unable to pump
water from the water jug to the
boiler.
The causes may be:-
a) empty pitcher
b) a leak in the hydraulic
circuit
power circuit.
Check that there is water in the pitcher.
c) a broken pump
d) an electronic failure in the
Turn the oven off and then on again
If the failure occurs again, make a note
of the error code and then contact the
Baumatic Service Department, advising
them of this code.
E
0
RR
02
BOILER PROTECTION ALARM Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
03
POWER CARD OVERHEAT Check whether the ventilation
requirements in the installation
instructions have been followed.
Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
0
E
0
RR
04
PT1000 oven cavity sensor fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
05
Food sensor fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
0
ERR
06
Boiler thermocouple fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
0
code.
ERR
007
Oven cavity steam presence
thermocouple fault
Make a note of the
contact the Baumatic Service
error code and then
Department, advising them of this
code.
ERR
008
Oven cavity overheating M e en
co ta
Depa
code
ak a note of the error code and th
n ct the Baumatic Service
rtment, advising them of this
.
ERR
009
NTC sensor fault Make
conta
Depa
code
a note of the error code and then
ct the Baumatic Service
rtment, advising them of this
.