39
INSTALLATION
The installation must b by a suitably
qualified person, in accordance with the current
version of the following.
o UK Regulations and Safety Standards or their European Norm
Replacements.
o Building Regulations issued by the Department of the
Environment).
o Building Standards (issued by the Scottish Development
Department).
o IEE Wiring Regulation
o Electricity At Work Re
Before connecting the applianc
marked on the Rating Plate co
voltage.
WARNING: THIS APPLIANC
o itched
mm contact separation and placed in
n
o To connect the oven
on the terminal blo
inside. Make the co
cable clamp p ovide iately close the terminal
block cover again.
o If you have to change the oven power cord, the earthing
(yellow/green) conductor must always be 10 m
ductors
o Care must be take ains
supply cable does not exceed 50°C.
o If the mains su
by an appropriate replacement which can be obtained from the
Baumatic Spares Department.
e carried out
(
s.
gulations.
e, make sure that the supply voltage
rresponds with your mains supply
E MUST BE EARTHED.
This appliance should be wired into a 13 A double pole sw
fused spur outlet, having 3
an easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located i
its housing.
power cord, loosen and remove the cover
ck, in order to gain access to the contacts
nnection, securing the cord in place with the
d and then immedr
m longer than the
.
n to ensure that the temperature of the m
line con
pply cable is damaged, then it must be replaced
To Next Page
Loading...
