35
oiler wash
IM O be
followed. You should switch off the appliance at your mains supply
efore attempting the following procedure.
ith
e left inside of the water jug.
the
th or small sponge, before
replacing them.
ilter, ensuring that they are in the position
B
P RTANT: After completing boiler descaling, this process MUST
b
o After boiler has been descaled, dirty water will be emptied into
the water jug.
o YOU MUST empty the water jug, then rinse it out and fill it w
clean water. This should be done several times to make sure
that there is no residu
o If water drips from the filter container, you should unscrew
cap, filter and gaskets from it. Dry all of these parts and the
filter container thoroughly with a clo
o IMPORTANT: YOU MUST replace the two white gaskets when
reinserting the f
shown in the above diagram. You should also make sure that the
cap is turned until it is fully tightened inside of the filter
container.
To Next Page
Loading...
