Code: IU.01.09.0045
Version/Revision: 2.000
Page: 23 - 55
Drying cabinet
Model: EA-34-03
Failure or absence of grounding in the equipment, as well as poor sizing of the electrical
network, can compromise operator safety.
In places with a label indicating “Hot Surface” the temperature may exceed the body's limit,
which may cause burns or discomfort.
This equipment cannot be filled with flammable and explosive charges, as well as others that
are not included in this manual.
The instructions contained in this manual must be canonically followed to avoid malfunctions.
Before installing the equipment, carefully read the installation instructions in this installation
guide.
Maintenance and repairs must be carried out by accredited and qualified personnel.
For no reason should any safety components of the equipment be modified or altered.
During maintenance procedures, stress tests and/or functional examinations by accredited
technicians, the area around the equipment must be isolated, without the presence of users.
Only the responsible technician must be in the limited area. The demonstration of the work
carried out and the release of isolation will take place after the procedures are completed.
The equipment cannot be used to process products until all specified maintenance tasks have
been performed and recorded.
Operators using the equipment must be qualified to operate it.
Both when supplying and removing loads from the equipment, use the correct PPE.
To clean the equipment, turn off the electricity supply. Wait for the equipment to cool down and
only then carry out the service.
To carry out maintenance, turn off the electricity supply. Wait for the equipment to cool down
and only then carry out the service.
Installation must be carried out by accredited and qualified personnel.
The images presented in this document are for illustrative purposes only and may vary due to
optional configurations requested at the time of purchase.
To Next Page
Loading...