6.3 Error messages
Fault must be rectified by the factory.
Fault must be rectified by the factory.
Value for trailing preset is void.
Exessively fast sequences, i.e. inadequate intervals between pre-
sets at high counting frequency.
Counting frequency for track A or B too high.
Counting frequency for batch counter too high.
● Error messages
and can be cleared
with the key.
7 Part number
NE212. AX A2
Supply voltage
1 24 / 48 VAC
2 85...265 VAC
3 24 VDC
Outputs
1 Relay outputs, B1 normally open
2 Relay outputs, B1 normally closed
3 Electronic outputs PNP
4 Electronic outputs NPN
Interface
0 Without interface
1 RS485
2 RS422
3 RS232
To Previous Page
Loading...
