Baumuller b maxx BM4400 - Manufacturer Specific Parameters (SIX 0 x1 A;ro)

Commissioning/Operation
Instruction Handbook b maXX (BM4-F-)ENC-XX (Encoder module)
Document No.: 5.01042.12
71
of 102
8
8.2.2 Further information on parameterization
The basic setting of the parameter „configuration encoder“ you will find in the following
table:
Figure 17: Parameter for configuration
1)
Length measurement system: display only, value from P0574 and P0578
Rotary sensor/angle measurement system: PPR count encoder
8.2.3 Function test
The (BM4-F-)ENC-XX can only be tested in connection with the basic unit b maXX 4000,
motor and encoder. Further information can be found in the Instruction Handbook and Pa
-
rameter Manual b maXX 4000.
Resolver Resolver Sine cosine encoder with Hiperface
®
or Endat
®
and electronic type plate Sine cosine encoder with SSI interface with/without 5V encoder supply Encoder with SSI interface and 24V encoder supply 5V square wave incremental encoder Sine cosine incremental encoder
(BM4-F-)ENC -01, -
11
-21 -02, -12,
-05, -06
-07, -17 -27 -03 -04, -08
P0150 Encoder 1 mode
P0160 Encoder 2 mode
0001
hex
P0152 Encoder 1 PPR count
P0162 Encoder 2 PPR count
1 1 automatic
setting
encoder
PPR
count
depen-
dent on
encoder
1)
encoder
PPR
count
encoder
PPR
count
P1071 Encoder 1 smoothing time
P1081 Encoder 2 smoothing time
3,0 1,0 Value depends on different factors, e.g. encoder
PPR count, quality of sine-cosine-signals, analog
or digital position transmission
P1073 Encoder 1 N=0 threshold
P1083 Encoder 2 N=0 threshold
1,00
P1075 Encoder 1 N>Nx OFF threshold
P1085 Encoder 2 N>Nx OFF threshold
96,00
P1074 Encoder 1 N>Nx ON threshold
P1084 Encoder 2 N>Nx ON threshold
100,00
P1072 Encoder 1 overspeed
P1082 Encoder 2 overspeed
115,0