Troubleshooting and fault correction
Instruction Handbook b maXX (BM4-F-)ENC-XX (Encoder module)
Document No.: 5.01042.12
77
of 102
10
Operating
software ProDrive
Furthermore the error message is shown in the operating software:
h Start the operating program ProDrive (from FW 3.07), if it isn’t running yet.
Display the „error message“ in ProDrive:
h Open navigation with click on + in front of „Management“
Figure 19: ProDrive navigation
NOTE!
The controller software version and the operating software version must be compat-
ible to use ProDrive with all functions.
To Next Page
Loading...
